High Grade Lubricant  is an innovation scientifically blended engine oil treatment to

1. Reduced dark smoke (no more smoke belching problems) and unburned carbons which are major contributors to air pollution and global warming problems.
2. Reduce oil pollutants because used oil is being recycled and reused.
3. Give Maximum Engine Protection from destructive friction and overheating thus it reduced costly repairs both labor and spare parts.
4. Improve engine performance and engine efficiency.
5. Restore the used oil and improve its properties.
6. Prevent engine foaming.
7. Increase millage per liter or to help you save of fuel between 10% up to 30%!
8. Cleans your engine.
9. Be an oil additive to motorcycle oil, transmission oil, differential oils, gear box oil, compressor oil, pumps oil, etc. to improves its efficiency, performance at extend its economic life.

How to apply?

Example 1: Car that is using 4 liters (4,000 ml)  of engine oil.

Run the engine in idle for 5 minutes. Add  500ml of High Grade Lubricant. The percentage is 12.5% base on designed oil capacity.  Run the engine in idle for 10 minutes. Wait for 10 minutes then check the oil level. Drain the excess oil if it reaches above the maximum level. Repeat the procedure every 5,000 km of travel.

Example 2: Motorcycle that is using  1 liter or 1,000 ml of engine oil for 2 stroke or  motorcycle with dark smoke

Run the engine in idle for 5 minutes. Add  250 ml of High Grade Lubricant (25 % base on designed oil capacity).  Run the engine in idle for 10 minutes. Wait for 10 minutes then check the oil level. Drain the excess oil if it reaches above the maximum level. Repeat the procedure every 3,000 km travel. 

Example 3: Motorcycle that is using  1 liter or 1,000 ml of engine oil for 4 stroke or  motorcycle with no dark smoke.

Run the engine in idle for 5 minutes. Add  125 ml of High Grade Lubricant (12.5 % base on designed oil capacity).  Run the engine in idle for 10 minutes. Wait for 10 minutes then check the oil level. Drain the excess oil if it reaches above the maximum level. Repeat the procedure every 3,000 km travel. 

Example 4: If an engine is using 1,000 liters of engine oil. 

Run the engine in idle for 10 minutes. Add  125 liters of High Grade Lubricant (12.5% base on designed oil capacity).  Run the engine in idle for 20 minutes. Wait for 10 minutes then check the oil level. Drain the excess oil if it reaches above the maximum level. Do this procedure on the previous schedule of change oil.